Sales@herooutdoors.com
USD
- Sleek new design. SKS gastube scope mount that replaces the factory gas tube and upper hanguard. Picatinny rail on top is designed to allow shooters to mount optics with long eye relief for a scout rifle setup
- Two set screws secure the mount to the rear sight trunnion for a solid optics mounting platform
- Low profile Picatinny rail with a sight channel down the middle to allow the use of iron sights
- Great for long eye relief scout scopes or reflex dot sights
- Two Picatinny side rails included, they can be mounted into any of the six ventillation holes and are also removable
- The Gas Tube is manufactured just slightly longer, so that it can be hand fited to the various manufacturers of the SKS rifles. Some handfitting may be required for a secure fit
- Aluminum (Rail) and Steel Construction (Gas Tube)
- Length: 9.8"
- Weight: 10.9 oz.
- US Patent: D732628
*Some Fitment may be required.
5 Reviews Hide Reviews Show Reviews
-
Good...
It will take a little bit of filing to get it to fit properly. However, it's good quality and works fantastic. I have over 200 rounds through it now and I've had no issues.
-
Well...
Still haven't figured out why people badmouth these. They are well built, and I use them on my sks as it's easier to clean. The original is always a pain to remove. These ( after filing) make it a breeze to remove and I actually have started using my sks more after I installed this as it's easy to get to piston and gas ports. Have used with corrosive ammo, and it holds up well.
-
It...
Looks great on my sks filing isn’t that bad just file then try to fit the directions that come with unit are very detailed. I wish the piston tube was a thousandth of an inch small in the inside diameter so the piston would stop with a thumb over the top but it still works and doesn’t shift around walking. Would buy again if need be.
-
quality product with some filling...
I like the product, but it does need a bit of filling work for it to fit on your sks. the gas tube it self on mine did not fit the gas piston and I had to use a dremel sandpaper bit to sand the inside of the gas tube to achive a proper fit.
-
exelent
exelent
